Pre Prime WB Epoxy Primer - Water Based - Clear - 250 + sq ft

  • Model: PPWB - Clear
  • Manufactured by: Original Color Chips Company

Description and Uses

Original Color Chips Waterborne Epoxy Primer is a two-component liquid epoxy emulsion. It's a low-solids epoxy

designed to sink deep into the concrete substrate to allow subsequent coatings better adhesi..

Price :
$67.17

Description and Uses

Original Color Chips Waterborne Epoxy Primer is a two-component liquid epoxy emulsion. It's a low-solids epoxy

designed to sink deep into the concrete substrate to allow subsequent coatings better adhesion and uniform sheen.

It can be applied on interior floors, walls, ceilings, and machinery equipment. It hardens to a tough tile-like finish.

Particularly suitable on almost any surface, in areas where an inexpensive, easy to clean and wear resistant coating 

is required. This waterborne epoxy primer can be used to prime a concrete substrate for use with waterborne, solvent-

borne, or 100% solids epoxy products. 

 

Characteristics

· Water basedTechnical Information

· No smell, non-toxic, ideal for in-plant applicationColor:Gray

 during normal operation.

· EconomicalSolid content: Per volume34-35%

· Resistant to mild corrosive chemicals Per weight40-45% 

· Highly scrub and wear resistant Varies with color 

· Allow for easy application

· WashableV.O.C. 110 g/l (0.92lbs/US gallons)

 

Mixing ratio: 3 parts A to 1 part B (hardener)

Application Instructions per volume

Surface Preparation

All surfaces to be coated should be free of wash, oil,Pot life: 2 hours

grease or any other contaminant. Should be properly 

etched using chemical or mechanical means.Application Spray, roller, or brush

Method: 

Application

It is recommended to stir part A before adding part BCoverage: 250 sq. ft. per kit

as some soft setting may occur in the containers 

during storage.Recoat time: 8 - 12 hours

 

Mix parts A and B mechanically for 5 minutes inCuring time: Dry 8 hours

recommended proportions. Full cure 7 days

 

Apply thick using a 3/8" nap roller for best results. Thinning solvent: Water

 

Recoating: You can recoat over this product at the Cleaning solvent: Water

point where you cannot leave your fingerprint in the  

epoxy. If you press your finger onto the coating and Shelf life: 2 years in original unopened

you cannot see your fingerprint you are ready to apply container

your next coat. 

 Packing: 1 US gallon / 3.78 liters

Precautions

· Do not apply material at temperatures below 

 0°C (32°F).

· Do not freeze.

· Material might be affected by certain corrosive

 chemicals.

 

Waterborne Epoxy Primer Coat PDF

Customers also purchased