Devoe Pre Prime 167 Penetrating Epoxy - 100% Solids - 1 Gal

  • Model: DC167K0000/A1GL
  • Manufactured by: Devoe Coatings

Preprime 167 is currently backordered with no ETA. We apologize for any inconvenience. Alternatively, we do offer our Norklad Preprime WB Primer which covers 250sqft per kit.

..

Price :
$119.00

Preprime 167 is currently backordered with no ETA. We apologize for any inconvenience. Alternatively, we do offer our Norklad Preprime WB Primer which covers 250sqft per kit.

Devoe Pre-prime 167 - Penetrating Epoxy Primer (500 sq/ft)

Advantages:
• Low VOC
• Reinforces rusty steel, masonry, and aged “White-Rusted” zinc surfaces
• Penetrates surface rust, crevices, back-to-back angles
• Penetrates pores and tiny cracks in concrete and masonry surfaces
• Cures to a tough, water resistant coating
• 100% volume solids
• Very low viscosity
• Low film thickness required
• No shrinkage
• Applies easily by brush, roll, or spray

Limitations of Use: Not recommended for use without a topcoat. Do
not puddle on horizontal surfaces.

100% solids, so it can be topcoated even when tacky. (no solvents to evaporate out of the coating)

 

The Preprime 167 penetrating sealer will improve the effectiveness and efficiency of the devoe coating by penetrating and sealing the concrete plus provide an additional bonding coat for your basecoat; improving the service life of the maintenance system. It's 100% solids so it will create a vapor barrier/sealer for your floor.

The entire contents of each container (part a and part b) must be mixed together. Add the converter portion to the base portion slowly with continued agitation. Once the two components are mixed you have 4 hours to use it. The Preprime has a very low viscosity (much like water) so usually one gallon will coat over 500 sq ft on properly prepped concrete. It MUST be applied in one thin, wet coat sufficient to completely cover and penetrate the surface. Do not apply heavy coats. There should be NO POOLING, just a thin layer to soak into the concrete. After it has been applied, wait overnight before applying basecoat epoxy. (or wait until the preprime becomes tacky and use spiked shoes to start painting your basecoat). Note: must be topcoated within 72 hours of application.

 

 WE CANNOT EXPEDITE THIS ITEM:  Some components in this flooring system may not be eligible for expedited shipping (Next Day Air, 2nd Day Air, or 3-day Select) because they are considered hazardous materials and may not be allowed on airplanes. For rush shipment inquiries please contact us at 586-771-6500 to discuss the fastest shipping options to your location

Customers also purchased

  1. Home
  2. Devoe Coatings
  3. Devoe Pre Prime 167 Penetrating Epoxy - 100% Solids - 1 Gal